Glass cutting machine industry along with the continuous development of science and technology, has a great potential and broad market prospects, the following Eworld equipment
co. , LTD. To say to you about how to maintain, hope I can help you to extend the service life of equipment.
A, the equipment must ensure that the laser tube is full of circulating water before work.
When the automatic glass cutting machine
into the tank, open the water tank, take out the water pump, remove the pump composed of dirt.
Replaced the tank clean circulating water and revert to pump water tank, will be connected to the pipe inserted into the inlet of the pump, tidy up the joint.
The pump power and run 2 - alone
3 minutes, in order to make the laser tube is full of circulating water.
Two fan, glass cutting machine clean.
Accumulation of blower fan in use for a long time makes a lot of dust, solid to produce huge fan noise but also not conducive to the exhaust and in addition to taste.
When there is a poor insufficient suction fan, exhaust, the first thing to turn the power off, will be discharged into the duct and the duct on the fan, to remove the dust then fan upside down, and the inside of the blades, until clean, and then install the fan.
The above content is derived from the Eworld glass cutter's official website: WWW.
Shandong Eworld Machine Co.,Ltd guarantees to providing quality products and services.
Shandong Eworld Machine Co.,Ltd would like to provide our customers with as near perfect protection, as near perfect service as is humanly possible and to do so at the lowest possible cost.'
According to the latest social survey, more than 50 percent of consumers (across all age demographics) follow a brand before purchasing a product. Therefore, Eworld Machine's content can make or break a customer's decision to conduct business with you.
Shandong Eworld Machine Co.,Ltd's main technology of glass machine company leads us to understand and utilize information correctly.